Product Description
Copper powder, high purity, water atomized, hydrogen reduced very fine copper powder with irregular particles and clusters. Relatively lower Density.
May be used for diamond wheels, sintering, chemical reactions as well as other applications were the purity and conductivity of product is important.
HTS Code: 7406.10.0000
NMFC: 30743
CAS: 7440-50-8
Recommended for:
- Thick and Thin Film pastes
- Conductive Inks, paints and pastes
- Injection Molding
- Thermal management
- EDM Electrodes
- Antifouling Paint
- Thermal Sprays
- Sintered alloys/ products
- Brazing/ soldering paste
Typical Analysis:
Copper: 99.3%
Hydrogen Loss: 0.39%
Apparent Density: 2.6 - 2.8 g/cc
SIEVE ANALYSIS
+100 MESH: Trace
+140 MESH: 1% Max
+200 MESH: 3% Max
+325 MESH: Balance
-325 MESH: 90% Min
Note: Pure copper powders do not show continuity or conductivity by a multimeter. I think there are two reasons for that. One is the low voltage used for the test. The other is lots of air and weak contacts between the particles. They will show conductivity with higher voltage, when they are compacted and when they are mixed with some oil or resin to form a paste.
